The cooling filter is very important in avoiding the development of dust, grease and various other small fragments within the cooling unit itself. Without the filter, all the dust and particles that are caught by the filter would be deposited straight onto the fins, resulting in that area becoming stopped up, and shut. Once the air flow is limited around the cooling area, the system is simply unable to produce cold air. In addition, without the air conditioning filter, the particles and dust would adhere to the fins as they are moist due to the moisture produced in the cooling process, especially in damp climates. This can and will result in bacteria development in the system, that in turn, blows this bacteria back into the air that you are inhaling Click Here .
Cleaning the window air conditioning filter on a regular basis not only helps with cooling, but likewise helps with the effectiveness of the system. A good idea is to clean the filter prior to turning on the air conditioning unit in the spring, then again every three to 4 weeks while the system is being used. If you live in an area where there is lots of fine dust, cigarette smokers in your house might find that cleansing the cooling filter every two weeks is also more beneficial.
Window air conditioning filters are the simplest to clean and are normally made of either a sturdy foam kind of material or a fine mesh. The most common and recommended type of filter is made of polypropylene, which is actually electrostatic and will trap small fragments. To clean these sorts of mesh screens, just wash in warm soapy water and rinse well. Always allow the filter to totally dry prior to putting it back in the unit. Foam filters ought to be replaced with a brand-new filter that can be made in your home from foam sheets purchased at a home supply store.
A large outside standard cooling filter can be cleaned with commercial solutions, nevertheless, they often are not as effective after they have been cleaned. A better option is to simply remove and replace the large filters every two months of use. Brush the fins of the outside unit that are located behind the filters and remove all particles and dust either by blowing with compressed air or using a shop vacuum. Always try to keep the area around the outside unit free from long grass, bushes or vines that may block air flow or add particles into the unit or filter.